From a simple cut a very variable lamp is created with self-adhesive Lamp foil . The foil is covered with fabric and sewn together at the edges. This is very easy and extremely variable.
And that's it:
With the help of the templates, make templates, Lamp foil transfer them to the protective foil and cut them out. Important: The template for the side parts must be mirrored on the dotted line. Punch out the holes at the edges of the lampshade foil, through which you will later pull Ribbon , with the punching pliers
Spread out and straighten the fabric for the side parts and the lamp cover or base. Lamp foil Remove the protective foil from the fabric and stick the foil blanks onto the fabric. Cut off any excess fabric and slit the pre-punched holes with a scalpel
Shorten the sides of the covered lamp Lamp foil along the fabric pattern to the desired height of the lamp and then cut a hole in the lid to fit the lamp socket
The parts of the foil that are covered with fabric are now sewn together with ribbon thread, the ends are fixed with hot glue. Tip: Wrap a piece of adhesive film around the end of the ribbon so that it does not fray out and can be threaded through the holes more easily
Press the two ends of the cable into the holes with the metal slot in the socket (press firmly, the cable ends will snap into place) and click the two plastic parts together. Attention: afterwards they cannot be separated anymore! Lampshade Mount the finished lamp socket in the
The finished lamp can now further be decorated with a duck, with Satin ribbon and roses or other accessories
